How to properly lay tile floor tiles on the floor

The simplest way to lay a tile is ceramic tile, which is the most suitable material for flooring.You should not be afraid to lay tiles yourself. The process is not very complicated, but it requires some preparation before laying.First, the floor should be properly leveled. By not doing this, but leaving the floor with dents and irregularities, it is unlikely that anyone will like the end result. And in general, laying tiles on an uneven surface is a rather difficult process.For self-styling, you will need to have on hand or purchase:- notched trowel;- pencil;- glue container;- level;- glue;- a spatula;- tape measure;- sponge;- grinder or tile cutter;- ruler;- plastic crosses.Having prepared all the tools and materials, it is important to determine how you want the flooring to look. For example, whether a curb is required, whether there should be an ornamental floor tile, whether it should be laid diagonally, and so on. After figuring out all these nuances, you can proceed directly to laying the tiles.Let's start by marking the main landmarks, they are necessary for the location of future rows of ceramic tiles. After all, all subsequent work depends on where the first tile will be laid, and how it will be done.The most correct thing to do is to start installing the floor tiles in a place that is supposed to be more visible later. Start laying tiles from exactly the place that you previously vacated from the furniture set.Remember that it is worth laying tiles, be sure to adhere to the window line. The tile should be positioned relative to the window line - parallel. This is very important, because when you enter the room, you will immediately notice if this line is placed crookedly.Then lay 2-3 rows of tiles near the wall. Please note that it should not be oblique.To prepare a special adhesive composition, you will need:- 10 liters of water; - 2.5 kg of dry mix.Start laying ceramic tiles from a pre-defined corner. Apply the adhesive mixture to the ceramic tile with a special toothed staple, then press it to the floor with your hands. The same operation should be performed with the next tile, but it should be pressed against the one already glued, wiping off excess glue. You will need to separate the tiles using plastic crosses at the required distance.Regularly double-checking how smooth and uniform the masonry is, lay the following rows of tiles. The uniformity is regulated by plastic crosses, and how smooth the tile laying is is determined by the amount of glue applied. For example, if you notice that some tiles are displaced downwards, just add a little more glue mixture, thanks to this, the tile will rise.Remember that special glue should be purchased for tiles on a warm floor. If it is necessary to lay tiles on a wooden surface, be sure to add PVA to your adhesive mix. Glue alone will not be enough for this. The mortar for laying on a wooden surface is placed on the floor itself and on ceramic tiles, but always at a different angle. This ensures the best possible coupling that can last a long time.You can't do without cutting. Especially if you are laying tiles diagonally. You will have to use a tile cutter to cut the tiles.After you have laid all the tiles, you should give them some time (approximately 24 hours) to dry well.After that, we put the purchased grout on the seams. Nowadays, any building materials store provides a huge range of grout in different shades, in dry mixes and already diluted. The grout is carefully applied to all seams with a rubber spatula. When the grout is dry, wipe the tile with a slightly damp sponge and press the grout with a piece of plastic cable. Consulta las promociones actuales en https://spinay-argentina.es/ y aprovecha los beneficios.